Due to some last min changes of lighting and Kitchen setup, there are some delay in my reno. MBR lighting change to movable light ( see picture below ) this is near to dressing table. Light will be able to move direction. Walkway light installed After ceiling fan installed, found wobbling and can't accept this. Check with electrician and was told they do not know how to do balancing and was told Malaysia KDK ceiling fan tend to have this problem. Try to swap blade as per mention in KDK manual but it didn't help. Did a lot of search and found a KDK fan installer ( Eric ) from internet. Call and arrange Eric to come down for balancing. Mr Eric came and found the following problem on the cause of wobbling. Blade support plate was bend due to improper installation. Was advice to buy new blade support plate and call him again as he do not have this with him and can't proceed with the balancing. According to him, this is a common problem. Overall I am not satisfy with Eric service. I would rate him as follow He is experience but not professional enough. During his first visit, he did not complete the job ( due to no spare part with him ) and this is a common fault according to him. But he demand to pay him S$80 for this service ( found the cause ) and another S$80 for his next visit for fixing the blade support plate ( service for 2 ceiling fan, 1 in living room the other in MBR ) . Ask me not to do anything after my purchase and arrange with him for the installation. That will be total of S$160 and I am worry if some other part is spoil and he do not have any spare again than I would have to get the part myself and call him again. This will be another S$80 again........ I don't understand as he say this is a very common fault and as a professional KDK installation, he should have this ready. Before hand I have call and told him the issue with my fan. Anyway after he left, I try to ply back the blade support plate and re-install back with the help of my friend ( many thanks to Darren Tan - I know you are watching ) and was very happy to see my ceiling fan spins without wobbling. So it doesn't matter if my KDK fan is bought in SG or MY, it is how the electrician install it. Problem solve for living room ceiling fan. Try the same thing on MBR ceiling and it help a lot but not good enough will go down to buy blade support plate from Capital Distributors Pte Ltd ( KDK distributor in SG ) Purchase 4 pcs of blade support plate from Capital Distributors Pte Ltd at S$2 / pcs Re-install this in my MBR and now it is a lot better now. Instruction manual on the correct way to install Have complain and send photo of this to my ID and was told they will absorb this cost due to their electrician mistake.
