maxden

Hi Red, thanks for the compliments, let us help with your queries. - so far we have not heard anything that owner can't seal up a hopper permanently, just that you will need to walk out of your house to throw those rubbish. - to seal the hopper in the most economical way, use masking tape around the perimeter of the hopper. This method is reversable should you decided to use it again and it would not cost very much. - with the masking tape on, the stench can be eliminate almost entirely, so no worry about it. hope this helps, let us know if you need any further assistance. Cheers! Our government is very supportive to all SME. But some SME may need a 3rd party assistance/expertise for advice. hope this clarifies.

TGIF! attached is the newspaper article on Maxden hopper

Tip 5 Is your hopper airtight? How to test this? Simple, just look out for the day of fumigation/fogging. The notice normally will be post onto the notice board at the void deck area, ground floor. When it is about time, just stand there and watch. You may need to take leave or off day as this normally carry out during weekday at office hours. Or you may have already tape up the hopper and prepare for it. (standby insecticide or any broom if require) Non-airtight hopper, you will see smoke penetrating through the gap between the door and frame, and cockroach will be squeezing through as well (it is life and death situation for them) This is especially obvious for those staying at lower floor, and not so bad for those staying at higher floor. As the pressure from the fogging is always highest at the lower floor and lowest at the higher floor. hope this helps. TGIF!

Tip 3 Do you know that beside regular maintenance for the hopper, the hopper can be repair and even overhaul? Replacable parts (for Maxden's hopper only) - gasket (after 15years or maybe longer) - bucket (it may be smash up by the fallen object from high floor) - stopper (it may get deform in shape) - hinges (shearing may occur on the rivert) - door handle all the above are replacable, with the frame in place, thus no replacement is require as a new installation will create some level of noise and dust which is not desire. Tip 4 We have recently re-secured a entire hopper of other brand, the whole frame with door is shaking. upon close examin, we realise the 4 pins which hold the 4 legs from the frame, it either gone or loosen, thus we reinforce by firing new anchor pins into the 4 legs. The proper installation should be using of cement to permanently hold the entire hopper, instead of just securing it by the 4 pins. Another problem, the counterweight is missing, due to fallen object hitting and shearing off the riverts. A bolt and nut should be use instead of riverts. hope this helps.

Tip 2 For owner with Maxden hopper, regular applying of light oil eg. singer oil on the gasket (on all the 4 sides) will keep the gasket pliable and improve the lifespan of the material. For owner with other hopper, which material is of "sponge" type, we have no idea how should you maintain it as it is a kind of high density foam material. Perhap you can use some soft brush to clean the contact surface. However, just take note that the black foam is not being "compress" even below the metal rail, the foam is suppose to be contacting the door surface to maintain the "airtight" condition. Lastly, oil is infact, a better way to keep out cockroaches, why? Cockroach breathe through the skin, not like human through the lung. Thus any contact of oil on their body, will make them very uncomfortable and unable to breathe properly. So, keep your pesticide for those roaches which has invaded into your premises instead of spraying into the chute. hope this helps.

If it is just a partition wall or light weight panel, no issue with hacking and removing it. But if it is a structural wall, it is a no go. The structural PE will be able to advice you, from the drawing. hope this helps.

TGIF! Lets look at the regular maintenance of the hopper The hopper is often a neglected item in your home, however, it does not means you do not have to do some simple maintenance for it. A well maintained hopper can last you for many years, one of our pioneer customer had our hopper installed about 15 years ago and it is will functioning well today. Lets us look at some basic cleaning, maintenance of the hopper. Tip 1: the area under the bucket is always the forgotten part when you clean your hopper, and it is the most critical area as many crushed cockroaches, debris, unwanted stuff are commonly found there. And all this undesired stuff will hinder the closing of the door, thus the door are unable to shut properly. One simple way to do it, buy a baby milk bottle brush, or any "longish" brush, open up the hopper door, just push in this brush and all the dirt will be push out of the other end, just like brushing teeth. Another way, you could use your vacuum cleaner, with the narrow tip head, to vacuum all the dirt out from there (that is if you do not mind using your vacuum cleaner) hope this helps.

no idea about the energy saving campaign.. basically, aircon technology have evolve over the years, from piston compressor to rotary to screw etc.. perhap the 25degC is focus at those household with newer "energy saving" aircon? maybe you may want to experiment 2 different setting to monitor the consumption? hope this helps.

opps, i miss this.. 2 cents input, it will be lower consumption if you set the temperature to be lower, say 23 to 24degC. as at higher temperature setting, the aircon will cut out faster when the room reaches the setting. however, it will need to cut in again very soon, when the thermostat sense the temperature is rising. reason because, everytime the compressor cut in, there will be s surge of power supply been drawn and high ampere will be shown if you have a electrical thong to measure it. it will take a large current to start the compressor all over again after it is cut out. This process will be repeat over many times oin the night. lastly, frequent cut in and out of compressor, will shorten the life of the aircon system. hope this helps.

hi, aircon could be the prime suspect as the older model aircon, tend to consume more electricity. By the way, what is your thermostat setting at? eg 24degC ??

Dear all, some discussion of hopper this is discussion thread by some forummers over other forum of the hopper we hope it does not clash with renotalk policy.

Hi GMC, thanks. the above posting is mainly for education purpose. as of market trend nowaday, hopper is just not another "unsightly" piece of metal hanging onto the wall, it is now, also part of the "deco" when the house is renovated, as what we have found out from many home maker. just hope the above pictures and explainations help all the house owners to select a presentable and correct hopper.

Short/ narrow water drip (structure) A recent job at a condo at Tg Rhu water mark stain on the wall, due to narrow water drip, in which unable to stop the water from splashing inward during the flushing process.(we have rectified this problem) upon full opening, we discover the counterweight is missing from the bucket end. Look at the shape of the bucket, it is due to narrow water drip structure, thus the bucket is constantly being hit by fallen object from higher floor, even the bolts which hold the bucket was being shear off, causing the counterweight to fall off. look carefully at the both end, bucket edges are starting to split and already splitted so remember, to choose the correct bucket length in accordance to your wall structure depth.

Why Fire-rated? For all condominium, it is no issue as it is mandatory for all private apartment to install fire-rated hoppers. For HDB, it is not a requirement as it is exempted. With reference from recent Straits Time article, there is a rise of rubbish chute fire, as reported by SCDF. Thus we reckon, it will still be better for those lower floor residents to install fire-rated hopper from the open market. FLAMES engulfed a rubbish chute in Ang Mo Kio Avenue 4 yesterday morning, forcing a conservancy worker to douse the fire with a nearby hose. By the time the blaze was put out, all that remained was the burnt-out hulk of the rubbish bin and a foul stench. RELATED LINKS SCDF REPORT CARD Investigations are ongoing, but residents suspect someone had mindlessly dropped a cigarette down the chute from a unit in the 15-storey block. This scene, which is repeated three to four times a day, is the leading cause of fires at residential blocks. In the first six months of this year, there were almost 1,100 blazes in rubbish chutes, garbage bins and common areas such as lift lobbies and void decks, according to figures released yesterday by the Singapore Civil Defence Force (SCDF). That was a 10 per cent rise over the same period last year. SCDF operations director Anwar Abdullah said rubbish fires are 'pretty much confined', but the blazes can mushroom if chutes contain flammable materials. They can create a lot of smoke and affect young children, seniors and those with respiratory problems. The blazes also make life harder for the cleaners who have to sweep up the mess, like Mr Yusof Khirul. The 27-year-old conservancy worker at Bishan Street 11 has done his fair share of fire-fighting. In the past six months, he has been called by residents to put out four rubbish fires. The Hungry Ghost Festival and Hari Raya cause him the most concern, because residents often forget to extinguish joss sticks and sparklers. 'They don't even think carefully about their actions, they just throw,' he said. Mr Lim Chin Huat, a conservancy worker in Bishan Street 13, found himself battling a blaze two weeks ago. It was the 62-year-old's fifth rubbish chute fire this year, one he said was sparked by burning charcoal. 'It's terrible. We can't even find out who it was that threw the charcoal into the chute. A dustbin has also been destroyed for no reason,' he said. Estates in Ang Mo Kio and Bishan have posted pamphlets at lift landings, advising residents to extinguish burning items before throwing them down rubbish chutes. But some ignore the advice, leaving their neighbours hopping mad. 'It's so inconsiderate,' said Mr Gabriel Ong, 39, who works in sales. 'This kind of behaviour affects the whole block and it's so dangerous especially if you live on the lower levels.' While the SCDF said the fire starters are difficult to catch, it has been keeping track of housing blocks with repeated flare-ups. Civil defence volunteers visit problematic blocks, advising residents to avoid tossing burning garbage. Dropped items such as cigarette butts, charcoal embers and candles caused over 60 per cent of the 2,545 fires reported in the first half of this year, according to the SCDF. That was one of several figures released yesterday. While fires around residential premises rose, it was a different story inside the homes. Household fires - including electrical fires, gas fires and cooking blazes - dropped about 8 per cent to just under 470, the lowest in five years. The SCDF's ambulance service saw a total of 59,000 calls, a 10 per cent rise over the first half last year. Burgeoning demand prompted the SCDF to earlier announce plans for private ambulances to start responding to emergencies in the middle of next year. SCDF chief medical officer Tan Eng Hoe said this timeline remains, though the tender has yet to be issued. Meanwhile, the public can do its bit by refraining from calling in false alarms. These jumped by a third to about 2,050 calls in the first half of this year. the link --> http://straitstimes.com.sg/Singapore/Story...ry_269941.html#

We have many enquiry about why Maxden hopper does not come with an integrated locking mechanism just some of our points: - for the past 30years in Singapore, there are about only 1 case of break in through the rubbish chute hopper, if someone really wanted to come into your premises, no hopper can stop them from breaking in. Check out today newspaper, a house was break into, the thief just smash down the metal window grill and came in through there. - With the above photo indication from previous posting, if the entire hopper installation was just using sealant to mount onto the wall, do you think it is still strong enough to prevent theft entry? even though the door is "locked", with strong force, the door with the frame will just give way. - Maxden hopper does not require a latch to keep the door close/shut, flush to the wall, we employ using pneumatic/magnetic gasket to do it (it comes with a patent on it) - Many a time, those hopper with a latch, dependent on the latch to ensure the door to shut properly/ flush with the wall, thus, if the latch mechanism is broken, many a time, the door can't close properly. - Also, if you notice, many aftermarket hoppers available in the market, most of the design look pretty similar with the flush handle and such? hope this clears most of the enquiries.