Hi Everyone,

I'm looking for an electrician to take a look at my place. Some of the lights are not working and when i take a look and tried to swap with a new lightbulb. It still doesn't light up plus there's no way for me to change the starter. So kindly if anyone had recommendation for electrian. The one whom did the lights for me was my ID's electrian but now uncontactable since. Really appreciate it very much.

Bro, my advise is mollify those bulb to LED, but still remain the light fitting. So in future you don't have problem of starter or ballet. LED nowadays is cheaper and save elect bill in long term

You could contact my electrician, jacky from Hoong Liang Electrical @ 8488****. Just mention that you are referred by Angeline who stays at 437 Tampines. Gd luck...

Bro, my advise is mollify those bulb to LED, but still remain the light fitting. So in future you don't have problem of starter or ballet. LED nowadays is cheaper and save elect bill in long term

my living room is LED. but some of the bulbs are out of light.

You could contact my electrician, jacky from Hoong Liang Electrical @ 84883140. Just mention that you are referred by Angeline who stays at 437 Tampines. Gd luck...

hi angeline. thank you so much. will contact him within this week. hope he can solve my lighting issues.

Can call my Electrician Ari 8591**** and refer my name Anand

Bro, my advise is mollify those bulb to LED, but still remain the light fitting. So in future you don't have problem of starter or ballet. LED nowadays is cheaper and save elect bill in long term

bro, care to explain more? my ceiling lights are the normal fluorescent tubes which uses starters and ballast , if I want to change to LED fluorescent tubes, do I need to remove the starter and ballast? Thanks in advance bro.. very new to all these things lah

Well, I too faced same situation earlier and thought that it is better to consult an electrician or any electrical consulting company before getting worse. I contacted Exengo and solved the problem.
<link removed>

Edited September 8, 201511 yr by leyenda

Is it solved yet?