Warrior88

solid black, try kiwi shoe polish ? not sure it works.

Different process. parquet is dry and dusty, marble is wet and creamy. Parquet is very very very dusty, dust even fly to the other room. I prefer both done last, if your furnishing is built in. It doesnt matter if floor below carpentry work is not polish. If your carpentry fail, time to polish the floor again too. Carpenty work/painting is very messy job, sure spoil the floor. even with corrugated cardboard.

Ya.. good choice simplehuman, nice design, quality stuff

Most purchase comes with installation of piping. Better to replace them, I can see that the current model is at least 10 years liao. If don't want old pipe just cut off and and touch up cornices. New trunking and drainage pipe can still be install outside. By the way, pls get rid of that PINK colour

If use invertor must change to bigger pipe

My suggestion, DON"T on the heater now, just use the cold until the problem rectified. There were cases of explosion due to defective valve, pressure relief valve. The pressure in the tank it exceeding the relief point. Don't play play Get agent if still under warranty, otherwise get a new one. maybe less than 200 include installation.

" scrap of some of the grout and put back new ones " Thats one way. Another way, I bought Leifheit grout paint. It comes in a bottle with a tiny roller. Just roll over the grout line. But problem is when the GL spacing too small, roller cannot fit in. By the way, painting also don't last long. Discolour pretty fast. So, regrouting still better. Just make sure surface clean and dry. Also allow it to dry after regrout.

Yoongf is the expert. I am clueless as you are. If I know, I would have rectified them as my conceal pipe is burst and that I have valve em now. Mine is a pte and the highest floor, happen occassionly only when I open the tap, not by certain time. I google a bit to find out. Guess if you are staying at the highest floor, debris from the tank will find its way to clog your pipe to cause this problem. I am also keen if anyone plumber can help :)

They wall actually breathe through the grout lines. Meaning moisture will pass through these lines. Thats why, some ppl recommend using grout sealer. But I think grout sealer is bad, cos your tiles cannot breathe. Thats why some tiles pop up.... This is only my opinion. I am no expert.

There is a big nut underneath the sink that mount the tap. You need a wrench or extended spanner to unsrew that nut to replace the washer.

Anyone knows where to get good and cheap sashimi knife that don't "rust"

This kind of wall fan, after a while cannot oscillation smoothly. Especially if you use you hand to turn it too much and often. just jam and make those clicking sound.

Yah... gout., uric acid, cannot take beans, aggravate by diabetes, cannot eat kway chup For narrow gap, must use unsanded grout, The absence of the sand will allow the grout to flow smoothly into the narrower space. Clean joint before apply. Allow 2 days for grout to dry then apply grout sealer.

Ping pong cover ? sure looks like paddlers bat. This is not through hole trap, it simply channel water to the main trap. Which means you need at least 1 inch of drain pipe gradient (slope) for water to flow. Not forgeting the ping pong cover height. So, that a lot of height to raise Check the main trap if there is enough depth. Pipe cannot go below the water proof membrance also. By the way, mine was done since I hack the whole floor. Don't forget to request for stainless steel cover. They will look nice with your stainless steel toilet accessories

Just a thought, perhaps a round table fit your square dining layout. Also, do take note of the orientation of your rectangular ceiling lights.

The tenant/seller agent do for me the transfer. They do like 1 day only. I don't know how.

"i come across as a bit upset" Don't be, read more forums, you see more absurb cases. Whether ethical or not. By right or wrong. OTP , rental agreement .. all can be void. Focus on the seller kindness for their earlier handing over. You should be smiling. okay brother

Thought those "LEGAL" money lenders that hunt around Toa Payoh can help

One of the tell tales sign is newspaper delivery if you order one. Your neighbour ? Clamp type padlock ? install CISCO alarm ? Let me take care for you .... just kidding

Can invite all forumers for sashimi buffet with dom perignon champagne after you collect the first rental

I had this problem too. Both in my toilet and kitchen tap. Each time this happen, I open the tap before to release the air lock (water hammer) **** thing is that, it doesn't happen everytime. This problem may aggravate to leakage in conceal pipe, which is what happen to my common toilet. Some says that there is dirt stuck in valve washer or pipe. Thus, sudden burst of water cause this problem. Water hammer arrestor only works sometimes. And must be install correct at the right place.

Toiletries .... thats all, put less easy to maintain. Nothing to put, keep it simple and nice

Sometimes ID are DIY type, will fixed up some of these at FOC. Some contractor will carry drill. ( Electrician, installer, carpenter..etc. ) Just get them to drill those 2 rivets out to fixed the problem temporary for servicing. After all, its MBR. Not that dangerous

Cannot meh ! My hse 1 key fits all grill lock. By the way, you insert the key first, a bit hard if you turn the key. After key insertion, you turn the lock. Grill lock are usually rivet mount, drill on the rivet and change new lock. But then again, you need the rivet gun and bullet. Got this gun at home, use once, and it is still in my storeroom :)

SGD230 for bifold is more like a branded one like BESGLAS. BESGLAS quality is better. PD Door, 1.5 times more, lighter, no under track and can use 1 hand to open/close. Easier to clean and can open 180%