Jump to content
Find Professionals    Deals    Get Quotations   Portfolios
Sign in to follow this  
Peter yoke

Where to buy good quality drill bit?

Recommended Posts


Join 46,923 satisfied homeowners who used renotalk quotation service to find interior designers. Get an estimated quotation

any neighbor hardware stores will sell the bits. else you can go to self-fix or homefix to buy the bits. make sure you get the correct type of drill bits for drilling walls and you have a hammer drill as well.

if you are planning to drill tiles, buy the type of drill bits for drilling tiles instead using the masonry bit for drilling walls. set your drill to normal drilling mode instead of hammer drilling mode. this will miminise the chances of cracking/chipping the tiles when drilling. after drilling through the tile, change to the masonry bit to drill the wall behind the tile so as not to damage the tile drill bit.

most contractors can't be bothered to use a tile drill bit when drilling the tiles in toilet or kitchen and cause cracks/chips on the tile.

 

Share this post


Link to post
Share on other sites
On 8/23/2018 at 12:14 PM, snoozee said:

any neighbor hardware stores will sell the bits. else you can go to self-fix or homefix to buy the bits. make sure you get the correct type of drill bits for drilling walls and you have a hammer drill as well.

if you are planning to drill tiles, buy the type of drill bits for drilling tiles instead using the masonry bit for drilling walls. set your drill to normal drilling mode instead of hammer drilling mode. this will miminise the chances of cracking/chipping the tiles when drilling. after drilling through the tile, change to the masonry bit to drill the wall behind the tile so as not to damage the tile drill bit.

most contractors can't be bothered to use a tile drill bit when drilling the tiles in toilet or kitchen and cause cracks/chips on the tile.

Would agree with this totally, good advice

 

Share this post


Link to post
Share on other sites

You will need to decide what drill bit size to buy and the corresponding anchor size that will fit into the drill hole. I suggest using a 6mm drill bit as a start.

 

Share this post


Link to post
Share on other sites
On 10/21/2018 at 8:56 PM, home05 said:

suggest using a 6mm drill bit as a start

That is actually a good idea because i think the last thing anyone would want to have is hole patches so start with a small hole first and then work your way up if needed

Edited by WordSmith
 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

Aura Sink


×